Dee Zee 123000-06 User Manual

Rp-10 rotary hand pump for fuel and petroleum, Owner’s manual

5252 East 36th Street North

Wichita, KS USA 67220-3205

TEL: 316-686-7361

FAX: 316-686-6746

“A Great Plains Ventures Subsidiary”

www.gpi.net

1-800-835-0113

GENERAL INFORMATION

The RP-10 Rotary Hand pump is designed for use with gasoline

(up to 15% alcohol blends such as E15), diesel fuel (up to 20%

bio-diesel blends such as B20), kerosene and up to medium

weight oils. These self-priming pumps deliver up to 10 gallons

(38 litres) per 100 revolutions and are designed for use on a tank

with a 2-inch bung. They are equipped with an anti-siphon vent

to prevent possible tank siphoning. Do not use the RP-10 pump

with chemicals.

Safety Instructions

Observe standard safety precautions when handling fuel.
• Keep away from open flame or spark.
• Do not refuel vehicles or equipment with engines running or

while equipment engine is hot.

• Do not smoke while refueling.

Before installation, clean the tank interior of dirt and foreign mate-

rial. Wrap all threads that are exposed to liquids with 3 to 4 turns of

Teflon

tape or a thread-sealing compound approved for use with

petroleum fuels. Remove protective covers and plugs.

OPERATIONS

1. Hand-tighten the riser on to the tank bung.
2. Assemble the crank and handle. Then snugly tighten the crank on-

to the shaft. Reference the Illustrated Parts Drawing for details.

3. Screw the suction pipe into the pump inlet.
4. Extend the suction pipe to its full length. Insert it through the

riser and into the tank. Adjust the suction pipe to the length

needed to rest on the tank bottom. If tank debris is a potential

problem, raise the end of the suction pipe 2 to 3 inches.

5. Secure the pump onto the riser with the two set screws. Tighten

until snug.

To install the hose and nozzle, thread the elbow fitting into the

pump outlet and tighten until snug. Hand-tighten the hose into the

elbow until snug. Tighten the nozzle onto the hose fitting. Insert

the nozzle into the hanger.

To dispense fuel, remove the nozzle from its hanger and insert into

a tank. Pump fuel by rotating the crank in the direction of the ar-

INSTALLATION

Rev. C 921462-06

RP-10 Rotary Hand Pump

for Fuel and Petroleum

Owner’s Manual

SAVE THESE INSTRUCTIONS

04/08

Use

standard

padlock

to secure

handle.

row on the housing. After dis-

pensing fuel, drain the hose

and replace the nozzle in the

hanger.
During daily use, this pump is

essentially maintenance free.

However, the pump should be

inspected periodically for signs

of leakage. If leaks are present or