Dee Zee FX27944 - Manual (Page 4)

WRENCH/RATCHET
3/8", 7/16"
TAPE
MEASURE
TIN SNIPS
CLAMP
3/16" DRILL BIT
1/4" DRILL BIT
Place the rubber trim onto the back lip of the running board. Cut the trim to length using tin snips.
Slide three 1/4 x 3/4" slotted hex head bolts [K] into both of the bolt channels on the bottom
side of the running board.
TOOLS REQUIRED
1
Place the mud flap [C] onto the running board as shown below.
Secure the mud flap in place using a 3/8" socket or wrench and one black sheet metal screw [J].
Holding the bottom of the flap against the running board to minimize the
gap on the top surface, drill a 1/8" hole through the flap and board on the bottom side .
Attached the flap with a sheet metal screw [S] with a phillips screw driver or bit.
Repeat this step for the other end of the board.
2
FX 27944 2 OF 9 4/12/2012