Dee Zee FX27944 - Manual (Page 11)

Pressing the flap up against the wheel well opening, drill three 1/8" holes through the mudflap and
the sheet metal of the wheel well. Secure the flap using the sheet metal screw [S] with a
phillips drive bit or phillips screwdriver.
This is best accomplised by drilling the lowest hole, installing the screw and then repeating the
process as you move up the flap.
Repeat for the other end of the board.
14
Check all hardware to make sure it has been tightened.
Repeat the assembly steps for the other side of the vehicle.
FX 27944 9 OF 9 4/12/2012