Dee Zee FX27944 - Manual (Page 10)

Align the bolt in the channels on the bottom of the running board with the slots in the braces and
insert the bolts into the slots. Loosely attach the running board to the braces using the 1/4" flat washers [H],
and the 1/4" hex nuts [I].
It may be necessary to adjust the angle brace to align the slots with the board.
13
It may be necessary to adjust the angle brace to align the slots with the board.
If needed, loosen the bolts attaching the angle brace and adjust as needed.
Retighten the bolts when the angle brace is in the correct location.
ADJUST BRACE AS NEEDED
Center the board between the wheel wells so that the flaps are aligned with the wheel wells.
Move the board in/out as needed to align it with the vehicle making sure that the bulb gasket
is in contact with the rocker panel.
Once the board is aligned, tighten the running board bolts using a 7/16" socket.
LOOSEN BOLT
LOOSEN BOLT
FX 27944 8 OF 9 4/12/2012