Dee Zee DZ3530 - Manual (Page 7)

Push up on the brace to put tension on the threaded plate in the large slot. Tighten the bolt
with the threaded plate using a 13mm socket. Air tools are recommended for this.
After the bolt with the threaded plate is tightened, tighten the remaining 8mm bolts.
Repeat this step for the other brace locations.
5
Pre-assemble the end cap [D] and strap bracket [F] using two 1/4" short bolts [G], four washers [M],
and two nuts [N]. Leave the parts somewhat loose for the next step.
6
DZ 3527 5 of 8 12/11/2012