Dee Zee DZ3530 - Manual (Page 5)

Use the nutsert set tool [H] to crimp the nutserts in the holes.
Hold the nut on the set tool with a 15mm wrench. Tighten the bolt in the set tool with a 13mm
socket.
Torque the nutserts to the spcification below to insure they are set correctly.
Put a 8mm x 25mm bolt [J] through the top hole in the braces and thread into the
8mm threaded plate [K] until the bolt starts to come through the threaded plate.
3
2
Repeat this for the other braces.
DZ 3527 3 of 8 12/11/2012