Dee Zee DZ1532 User Manual

Page 10

Text mode
Original mode

Drill 1/4" holes up through the slots into the board at the locations shown below.

Attach the running board to the angle brace using the hex head bolt [G],

Attach the running board to the angle brace using the hex head bolt [G],
1/4" flat washer [H], and 1/4" hex nut [I]. Tighten using a 7/16" wrench and socket.

Check all hardware to make sure it has been tightened.
Repeat the assembly steps for the other side of the vehicle.

DZ 1532

8 OF 8

7/28/2011