Dee Zee DZ2044 - Manual (Page 5)

Measure back from the front wheel well and mark the lower rocker panel at 18", 41" and 68".
This will be the approximate location for the rocker panel bracket [E].
Make sure there is nothing on the bottom of the frame at these location that would obstruct the
channel / angle brace from being installed in the later steps. If there is an obstruction, move the rocker
panel bracket to the front/rear as needed.
3
4
The bottom of the mounting bracket should be 1" below the bottom of the pinch weld.
Mark the hole location in the vertical long leg of the mounting bracket .
Remove the bracket and drill a 1/4" hole through the pinch weld.
Repeat this for each bracket location.
POINTING TOWARDS
THE FRAME
DZ 2044 3 OF 10 8/14/2012