Dee Zee DZ2044 - Manual (Page 10)

Place the running board on the angle braces. Adjust the angle braces as needed to insure that the
holes can be drill through the board to attach it to the braces.
The bolts holding the angle brace to the mounting bracket and frame bracket will have to be loosened
to adjust the brace. Once the brace location is set, re-titghten the bolts.
ADJUST BRACE AS NEEDED
Adjust the board to make sure the flap is up against the inner portion of the wheel well.
Then adjust the board in/out to make sure it is straight with the vehicle and that the gasket
on the backlip is in contact with the rocker panel.
Once the board location is set, clamp the running board to the angle braces.
13
14
CLAMP BOARD TO CLAMP BOARD TO
BRACE
DZ 2044 8 OF 10 8/14/2012