Dee Zee DZ2044 - Manual (Page 11)

Drill 1/4" holes up through the board using the holes shown below.
For the middle and rear location, drill through either the 1st and 3rd slot, or the 2nd and 4th slot.
15
1st
3rd
4th
Attach the running board to the angle brace using the 1/4" x 1" ribneck carriage bolt [F],
1/4" flat washer [H], and 1/4" hex nut [I]. Tighten using a 7/16" wrench or deep well socket.
Repeat at each brace location.
16
2nd
DZ 2044 9 OF 10 8/14/2012