Dee Zee DZ1032 - Manual (Page 9)

Attach the frame bracket to the frame using two sheet metal screws [J] using a 3/8" socket.
Remove the clamps holding the frame bracket [F] to the frame.
Repeat this step for each bracket location.
Adjust the board to make sure the flap is up against the inner portion of the wheel well.
Then adjust the board in/out to make sure it is straight with the vehicle and that the gasket
on the backlip is in contact with the rocker panel.
11
12
on the backlip is in contact with the rocker panel.
Once the board location is set, clamp the running board to the angle braces.
DZ 1032 7 OF 9 7/28/2011