Dee Zee DZ1032 - Manual (Page 5)

Measure back from the front wheel well and mark the lower rocker panel at 22", 47" and 76".
This will be the approximate location for the rocker panel bracket [E].
Make sure there is nothing on the frame at these three location that would obstruct the frame bracket
3
4
Make sure there is nothing on the frame at these three location that would obstruct the frame bracket
from being installed in the later steps. If there is an obstruction, move the rocker panel bracket to
the front/rear as needed.
Hold the rocker panel bracket on the outside of the rocker panel to determine where to drill.
Make sure the vertical part of the rocker panel bracket is inside of the edge of the rocker panel
before drilling. Mark the hole, remove the bracket and drill a 1/4" hole.
Repeat this for each bracket location.
4
DZ 1032 3 OF 9 7/28/2011