Dee Zee DZ16252 - Manual (Page 7)

Page 7 of 8
DZ 16252 04/15/09
Place bracket (B) between the front sides of brackets (F) and (D) and then place an 8mm x
25mm Hex Head bolt (K) through running board brackets and start the bolt into a M8 hex head
flange nut (L) in the side hole locations shown below. Tighten, but not completely. Next, place
an 8mm x 25mm Hex Head bolt (K) through running board bracket assembly and start the
bolts into a M8 – 1.25 single tab spot weld nut (J) in the hole locations shown below. Position
bracket into rear driver location with thread plate in vehicle opening and tighten, but do not
tighten completely.
4
13 mm
F
J
K
D
J
K
K
B
K
J
L