Dee Zee DZ16252 - Manual (Page 6)

Page 6 of 8
DZ 16252 04/15/09
Place bracket (B) between the front sides of bracket (C) and then place an 8mm x 25mm Hex
Head bolt (K) through running board brackets and start the bolt into a M8 hex head flange nut
(L) in the side hole locations shown below. Tighten, but not completely. Next, place an 8mm x
25mm Hex Head bolt (K) through running board bracket (C) and start the bolt into a M8 – 1.25
single tab spot weld nut (J) in the front hole location shown below. Position bracket into front
driver location with thread plates in vehicle openings and tighten, but do not tighten
completely. Then insert the M8 – 1.25 terwai nuts (I) through the bracket and into the rear hole
locations and start bolts (K). Again, do not tighten completely.
3
K
L
C
I
13 mm
B
J
K
K