Dee Zee DZ16212 - Manual (Page 8)

Page 8 of 9
DZ 16212 09/01/09
Place an 8mm x 25mm hex head bolt (K) through running board bracket (D) and start the bolt
into a M8 – 1.25 double tab spot weld nut (M) in the front hole location shown below. Place a
3/8”-16 x 1.25 hex cap screw (G) through running board bracket (D) and start the bolt into a
3/8”-16 large thread plate (I) in the rear hole location shown below. Position bracket into front
driver location with thread plates in vehicle openings and tighten completely.
K
D
K
13 mm
9/16”
5
M
I