Dee Zee DZ16212 - Manual (Page 7)

Page 7 of 9
DZ 16212 09/01/09
Place an 8mm x 25mm hex head bolt (K) through running board bracket (B) and start the bolt
into a M8 – 1.25 double tab spot weld nut (M) in the front hole location shown below. Place an
8mm x 25mm hex head bolt (K) through running board bracket (B) and start the bolt into a M8
– 1.25 single tab spot weld nut (J) in the rear hole location shown below. Position bracket into
front driver location with thread plates in vehicle openings and tighten completely.
4
M
K
13 mm
B
K
J