Monoprice 6514 Wall Mount Bracket - Manual (Page 5)

5 of 7
Installation of Solid Concrete or Cinder Block
Use wall plate (AA) as template to mark mounting
holes.The top mounting hole should be 3" above the
desired screen center as shown in figure A.1 on page 4.
Drill three 5/16"
(8 mm) dia. holes 3" (70 mm) deep as
shown in fig. B.1. Insert concrete anchor (C) in holes flush
withwall as shown (right). Place wall plate over anchors and
secure with M6x 60 screws ( D ). Level, then tighten all
fasteners.
‡ When installing the wall mounts on cinder block, verify that you have a minimum of 1-3/8" of actual concrete
thickness in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount in a solid
part of the block, generally 1" minimum from the side of the block. Cinder block must meet ASTM C-90 specifications.
It is suggested that a standard electric drill on slow setting is used to drill the hole instead of a hammer drill to avoid
breaking out the back of the hole when entering a void or cavity.
‡ Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.
‡ Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-
ware and components.
WARNING
CUT
A
W
A
Y
VIEW
INCORRECT
concrete
surface 1
3
2
C
Drill holes and insert anchors (F).
CORRECT
Place wall plate (D) over anchors (F) and secure with screws (E).
Tighten all fasteners.
wall plate
plaster/
dry wall
concrete wall plate concrete
plaster/
dry wall
‡ Always attach concrete anchors directl to load-
bearing concrete.
‡ Never attach concrete anchors to concrete covered
with plaster, drywall, or other finishing material. If
mounting to concrete surfaces covered with a finishing
surface is unavoidable, the finishing surface must be
counterbored as shown below. Be sure concrete
anchors do not pull away from concrete when tighten-
ing screws. If plaster/drywall is thicker than 5/8",
custom fasteners must be supplied by installer.
WARNING
‡ Tighten screws so that wall plate is firmly attached,
but do not overti hten. Overtightening can damage
screws, greatly reducing their holding power.
WARNING C
D
B
fig. B.1
solid concrete
cinder
block
y
g
C
D