Flaming River Corvette Rack and Pinion 1963-82 - Manual (Page 8)

7
Flaming River Industries
1-800-648-8022
FRxxxx Rev.A
01/05/11
Flaming River Rack and Pinion Installation
3) Install the OEM inner tie rod end into the Flaming River inner tie rod end on the new power rack.
Note: If using the original parts some adjustment of the tie rod assembly may be required when
connecting the to the spindle arm and the travel bar.
4) To install the outer tie rod end into the
spindles you must load the front sus-
pension. Securely place jack stands un
der the lower control arms and lowering
the car onto the jack stands. Make
sure that your wheels are centered,
then install the outer tie rod into the
rear hole on the spindle arms and tighten
the castle nuts to 30-40ft lbs. Make sure
to install the cotter pins through the castle
nut and tie rod end and bend the tabs
over.
Rack & Cradle Installed
In Car
Outer Tie Rod End
Inner Tie Rod End