AEG LAVAMAT 16950A3 User Manual

Page 15

By pressing Drying Time button it is also possible to dry up to 6 kg of cotton items (see the

«Drying Programme » table).

The water tap must be open and the drain hose must be positioned in the sink or

connected to the drain pipe.

Load the laundry.

Select a spin cycle at the maximum spin speed allowed for the type of laundry in order

to obtain the best drying performances.

Select the drying programme for Cottons or Synthetic in the Drying sector of the pro-

gramme selector dial. The DRYING and the ANTI-CREASE symbols corresponding to the

phases making up the programme appear on the display.
At the same time, the symbols corresponding to the level degrees allowed by the set

programme/fabric and «AUTO» lights up.

–

Set the automatic drying (button 3).
With this button you can select the degree of dryness by an electronic drying. The

machine adapts automatically the duration of the drying cycle to the selected de-

gree of dryness.
If you press this button, a black dash appears under the selected symbol to indicate

the degree set. The message «AUTO» disappears. The display shows the duration of

the drying cycle.
The pilot light of button

7 starts blinking. Press then button 7 to start the pro-

gramme. A black dash flashes under the DRYING symbol.

–

Set the timed drying (button 4)
Press this button, until the time you want appears on the display. Select the dura-

tion of the drying cycle from 10 to 250 minutes according to the type of fabric (cot-

ton or synthetic). Every time you press this button the drying time increases by 5

minutes.
The DRYING TIME DURATION symbol appears for a few seconds on the display near

the duration value. Press then button

7 to start the programme. A black dash flash-

es under the DRYING symbol.
Note!
The programme time will automatically increase by a few minutes.
Note!
If you set only 10 minutes of drying phase with the timed drying button, the appli-

ance performs only a cooling phase.

Press button

7 to start the programme.

After the programme has started, the time remaining is updated every minute.

At the end of the drying programme, the buzzer sounds. A blinking «

0» appears on the

display. At this point, begins an anti-crease phase which lasts for about 10 minutes.

During this time the ANTI-CREASE symbol appears on the display. The DOOR symbol

remains lit. The door cannot be opened.

Use - Drying