AEG LAVAMAT 16950A3 - Manual (Page 13)

Select the START/PAUSE (button 7)
To start the selected programme, press the button 7, the corresponding red pilot light stops
blinking.
The DOOR symbol appears on the display to indicate that the appliance has started operat-
ing and the door is locked.
To interrupt a programme which is running, press the button 7: the corresponding red pilot
light starts blinking.
To restart the programme from the point at which it was interrupted, press the button 7
again. If you have chosen a delayed start the machine will begin the countdown.
If an incorrect option is selected, the yellow pilot light of the button 7 blinks 3 times and
the message Err is displayed for a few seconds.
Select the DELAY START (button 8)
The corresponding symbol will appear on the display. The wash programme can be delayed
from 30 min - 60 min - 90 min, 2 hours and then by 1 hour up to a maximum of 20 hours
by means of this button.
Before you start the programme, if you wish to delay the start, press this button repeat-
edly, to select the desired delay.
The delay time value will appear on the display for about 3 seconds, then the duration of
the programme will appear again. The selected symbol appears on the display.
You must select this option after you have set the programme and before you press the
button 7.
You can modify or cancel the delay time at any moment, before you press the button 7.
The door will be locked throughout the delay time. If you wish to add laundry in the ma-
chine during the delay time, press the button 7 to set the machine to pause. When the
Door symbol disappears, the door can be opened. Add the laundry, close the door and press
the button 7 again.
Selecting the delayed start.
• Select the programme and the required options.
• Select the delay start.
• Press button 7: the appliance starts its hourly countdown. The programme will start after
the selected delay has expired.
Cancelling the delayed start
• Set the washing machine to PAUSE by pressing the button 7;
• Press button 8until the symbol ’ is displayed;
• Press the button 7 again to start the programme.
The selected delay can be changed only after selecting the washing programme again.
The Delay Start can not be selected with the draining programme.
Altering an option or a running programme
It is possible to change some options before the programme carries it out. Before you make
any change, you must pause the washing machine by pressing the button 7.
Changing a running programme is possible only by resetting it. Turn the programme se-
lector dial to and then to the new programme position. Start the new programme by
pressing the 7 button again. The washing water in the tub will not emptied out.
Daily use 13