AEG LAVAMAT 16950A3 - Manual (Page 11)

If you turn the programme selector dial to another programme when the machine is work-
ing, the yellow pilot light of button 7 will blink 3 times and the message Err is displayed on
the display to indicate a wrong selection. The machine will not perform the new selected
programme.
Select the spin speed, NIGHT CYCLE or RINSE HOLD option (button 2)
When the required programme has been selected, your appliance automatically proposes
the maximum spin speed provided for that programme.
Press this button repeatedly to change the spin speed, if you want your laundry to be spun
at a speed different from the one proposed by the washer-dryer.
RINSE HOLD: by selecting this option the water of the last rinse is not emptied out to pre-
vent the fabrics from creasing. At the end of the programme, a blinking and the RINSE
HOLD symbol appear on the display, the DOOR symbol (door locked) remains lit and the pi-
lot light of button 7 goes off. The door is locked to indicate that the water must be emptied
out.
NIGHT CYCLE: by selecting this option, the machine will not drain the water of the last
rinse, so as not to wrinkle the laundry. As all spinning phases are suppressed, this washing
cycle is very quiet and it can be selected at night or in times with a more economical power
rate. In some programmes the rinses will be performed with more water. At the end of the
programme, a blinking and the RINSE HOLD symbol appear on the display, the DOOR
symbol remains lit and the pilot light of button 7 goes off. The door is locked to indicate
that the water must be emptied out.
RINSE HOLD or NIGHT CYCLE option cannot be selected with a NON-STOP pro-
gramme (see Drying section). To empty out the water, please read chapter «At the end
of the programme».
Programme option buttons
Depending on the programme, different functions can be combined.
WARNING!
Not all the options are compatible among themselves. The symbols of the incompatible op-
tions disappear.
Anyway, if an option, which is not compatible with the set washing programme or any oth-
er option, is selected, the Err message is displayed for few seconds and the yellow pilot of
button 7 light starts blinking.
You must select the options after you have selected the programme but before pressing the
button 7. Press the button 5: all the option symbols appear on the display.
To scroll all the available options, press the button 5. The corresponding symbol appears on
the display and starts blinking.
Press the button 6 to activate and confirm your choice. A black dash appears under the
selected symbol to indicate that this option has been set. Press the same button to deacti-
vate the option.
After selecting the options, wait a few seconds until the display gets back to the default
status. The selected options appear on the display.
Daily use 11