Yetter 2961-012 Cut and Feed Coulter/Fertilizer User Manual
Page 4
4
GENERAL INFORMATION
The
2961 CUT-N-FEED
can be used as a R.H. opener or a L.H. opener, it is recommended that half
of the planter is R.H. assemblies and the other half if L.H. assemblies.
NOTE: The
2961 CUT-N-FEED
is NOT recommended for use in rocky conditions as the coulter arm
and fertilizer tube are susceptible to bending.
For proper operation of the
2961 CUT-N-FEED
, a ¼” NPT “Straight Stream” nozzle or a ¼” NPT
Female “Nozzle Body” with orifice plates will be required. Yetter Manufacturing Co. does not supply these
parts.
TABLE OF CONTENTS
Cover Page…………………………………………………………………………pg. 1
Foreword……………………………………………………………………………pg. 2
Safety Symbols and meanings………………..…………………………….……pg. 3
Table of Contents.…………………………………………………………………pg. 4
Torque Specifications..……………………………………………………………pg. 5
Operation…………………………………………………………………………...pg. 6
Adjustments…………………………………………………………………………pg. 7
Installation Instructions..……..……………………………………………………pg. 8-14
Liquid Fertilizer Application Rate & Pressure Chart……………………………pg. 15
Maintenance..………………………………………………………………………pg. 16-21
Parts Identification…………………………………………………………………pg. 22-25
Trouble Shooting…..………………………………………………………………pg. 26-27
Several different styles of blades are available for every tillage practice, every soil type,
and every residue condition, so you can choose the one that’s right for you.
BLADE CHOICE
FACTOR
SMOOTH (S) 13 WAVE (SW) 25 WAVE (MW)
SIZE 13"
X
X
14"
X
AGGRESSIVE LOW
X
MEDIUM
HIGH
X
X
SPEED
SLOW
X
NORMAL
X
X
X
FAST
X
SOIL DRY
X
X
X
CONDITION
DAMP/STICKY
X
SANDY
X
X
HEAVY
X
X