Sper Scientific 850071 Environmental Quality Meter - Manual (Page 13)

13
2. Press ▲or ▼ to select yes (touch-tone enabled)
or no (touch-tone disabled). Press ENTER to
save the selection.
Thermometer Type K/J
1. Enter the thermometer type function from Setup
Mode (see page 11). “tYPE” appears on the LCD.
2. Press ▲or ▼ to select K or J. Press ENTER to
save the selection.
Temperature Units
1. Enter the temperature units function from Setup
Mode (see page 11). “t-CF” appears on the LCD.
2. Press ▲or ▼ to select C (degrees Celsius) or
F (degrees Fahrenheit). Press ENTER to save
the selection.
Sampling Time
The sampling time is the time allotted between successive
measurements. To adjust the sampling time (in seconds):
1. Enter the sampling time function from Setup Mode
(see page 11). “SP-t” appears on the LCD.
2. Press ▲or ▼ to adjust the value (1, 2, 5, 10,
30, 60, 120, 300, 600, 1800, or 3600 seconds).
Press ENTER to save the value.