SIGMA ROX 6.0 CAD - Manual (Page 27)

ROX 6.0
www.sigmasport.com roX 6.0 Page 27
opening the lap view
General roX 6.0 functions
5.4 Opening the lap view
1 Press and hold the middle button (
LAP
) for three seconds. “Lap view oPen”
flashes on the display.
Press the
Set
and
Mode 1
button to switch between the following values: lap time,
time since start, lap distance, distance since start, max. speed, max. heart rate,
calories.
The average heart rate, average cadence, altitude ascent, and lap number are
shown in the top display segment. The average speed for the lap is shown in the
middle display segment.
2 Press the Reset and Mode 2 button to switch between the individual laps.
3 Press and hold the
LAP
button for three seconds to exit the lap view.
“Lap view cLose” flashes on the display.
5.5 Calibrating the start altitude
simultaneously press and hold the Mode 1 and Mode 2 buttons for three seconds to
calibrate the start altitude you have preset. “start altitude” flashes on the display.
If the start altitude has been calibrated, “set oK” appears on the display.
explanations about this function can be found in section “7 Altitude measurement
(IAc)”.
5.6 Stopwatch
1 Press the
Mode 2
button to move to the stopwatch.
2 Press the
Set
button to start and stop the stopwatch.
If the stopwatch is running, the icon appears on the display.
3 resetting the stopwatch:
Press and hold the
Reset
button for three seconds.
5.7 Countdown
1 Press the Mode 2 button to switch to the countdown.
2 Press and hold the
Set
button for three seconds. “countdown seT” flashes
on the display.
3 Press Mode 2 or Reset to increase or decrease the value respectively.
4 Press the
Mode 1
button to move to the next digit.
5 Press the
Set
button to save your setting.
“set oK” appears on the display.
Mode 1 Set
Lap
Mode 2 Reset
Set
Mode 2 Reset
Mode 1 Set