SIGMA ROX 6.0 CAD - Manual (Page 10)

ROX 6.0
www.sigmasport.com roX 6.0 Page 10
Attaching the bracket
Attaching the roX 6.0 and initial use
2 Attaching the ROX 6.0 and initial use
Note
see the quick start guide for detailed mounting instructions.
2.1 Attaching the bracket
− Attach to the handlebars or stem
− remove the yellow foil from the bracket (permanent attachment)
− The bracket can be attached using either cable ties (permanent attachment)
or the o-rings.
see attachment figures 1.1 1.2 1.3 1.4
2.2 Attaching the transmitter – speed and cadence
− both transmitters can be attached using either cable ties (permanent
attachment) or the o-rings.
see attachment figures 2.1 3.1
2.3 Attaching the magnets – speed and cadence
see attachment figures 2.3 3.2
2.4 Putting on the chest belt
− slightly moisten electrodes with water or cardio gel.
see attachment figures 4.1 4.2 4.3 4.4
2.5 Setting up BIKE 2
− CAUTION:
To switch the sTs speed transmitter to “bike 2”, use a ballpoint pen to press
and hold the small button on the back of the transmitter until a red LeD
flashes. (5 sec) (red LeD: bike 2; green LeD: bike 1).
see attachment figure 6.1
2.6 Attaching the SIGMA ROX 6.0 to the bracket
see attachment figure 6.2