Rubbermaid 1800384 - Manual (Page 3)

E
D
A
F
G
C
B
Steel door frame
3b
E
D
A
2
B
2
13/64”
1”
E
D
A
F
G
C
B
Right hand door
2b
D
4
Before Installation
Left hand door Right hand door
6” min
90˚
6” min
90˚
IMPORTANT:
The AutoDoor is supplied in the left hand
configuration. Refer to steps A through D
only if you require a right hand
configuration.
Step A–right hand door only
A
2
1
Step B–right hand door only
Determine the correct orientation of the unit (right or left
hand swinging door).
Remove cover and turn main unit over 180 degrees. Using a screwdriver, push three spacers through the inside of
the main unit.
Step C–Right hand door only
Replace cover.
Step D–Right hand door only
M
Insert the three spacers from the inside of the unit through
cover into and up in the main unit. Hold spacers in with
adhesive tape.
3
E
D
A
F
G
C
B
Wood door fame
3a
F
G
2
B
1
1/8”
1”
Tape template in place. For right hand door, mark hole locations
A, B, C, D, and E on the door jamb with an awl or center punch.
Note: Marking letters D and E for identification is recommended.
ENGLISH
2
E
D
A
F
G
C
B
1
1
E
D
A
B
H
Align Align Align
Hold the door open 90˚. Place template against the door jamb
aligning front edge of template with face of the door in closed position,
and the side of the template aligned with the face of the 90˚ door.
E
D
A
F
G
C
B
2a
Left hand door
F
C
Tape template in place. For left hand door, mark hole locations
A, B, C, F and G on the door jamb with an awl or center punch.
Note: Marking letters F and G for identification is recommended.
For steel door frames use 13/64” drill bit for holes A, B and C
(mounting holes). Use 1” step drill bit for holes D and E (F and
G for right hand door).
For wood door frames use 1/8” drill bit for holes A, B and C
(mounting holes). Use 1” wood drill bit for holes F and G
(D and E for right hand door).
Installation