Rubbermaid 1800384 - Manual (Page 2)

1 2
ENGLISH
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
E
D
A
F
G
C
B
Tools Needed
D
A
F
H
Fasteners
Optional Accessories
x2
13/64”
1”
1”
1/8”
E
G
x3
x2
x6
x6
B
C
Electric Strike Kit
#1800384
Entrance Sensor Kit
#1800382
Sensor Extension
Cable Kit
#1800383
O
E
x2
B
C
J
K
L
x2 x2
R
Q P
I
J
M x3
N
Auto Door main unit
sensor plate
sensor cover
main unit cover
20’ sensor cable roller plate
caution labels
drilling template
1/4”-14 x 1-1/2”
Phillips pan head
screw type AB
#6-20 x 3/4”
Phillips pan head
screw type AB
#6-32 x 1“
Phillips pan head
machine scew
#8”-18 x 1” Phillips
flat head countersunk
screw type AB
electric strike
electric strike cable
electric strike screws
electric strike anchors
sensor extension cable
A
B
C
D
E
F
G
H
I
Q
P
O
N
M
L
K
J
R
spacer
Parts List
Package Contents
Please confirm that all items shown in the image below are included in the packaging.
If any parts are missing, please call customer service at 1-800-347-9800.
WARNING: TO REDUCE THE RISK
OF SEVERE INJURY OR DEATH:
• Read And Follow All Installation Instructions
• If this product is installed incorrectly or the door is
adjusted incorrectly, the product will not operate
properly and could cause injury and/or equipment
damage. In such cases, the manufacturer’s warranty
becomes void and the manufacturer and seller
decline all liability ensuing from improper installation
or adjustment.
• Installation of this product must be performed by a
licensed and insured professional.
• Permanent wiring is to be employed as required
by local codes.
• DO NOT connect the Auto Door to source of
power until instructed to do so.
• Always disconnect power before removing
Auto Door cover.
• The Auto Door should only be installed in an
opening capable of providing proper structural
support. Install only on a properly operating door.
• The Auto Door must be inspected periodically using
the safety checklist in this manual.
• The door must be adjusted as described in this
manual before installation of the Auto Door.
Periodically check the adjustment control
mechanism.
• Ensure power supply is available in ceiling above
door jamb (120 volts; 60 hertz).
• Auto Door is intended for use on interior
pedestrian doors between 34”-42” wide
with a maximum weight of 170 lbs.
• Do not place hands near Auto Door arm when
operating.
Ensure that the existing door meets the
following settings and requirements:
• The door has a UL listed door closer mounted
on the pull side of the door (if not remove and
reinstall).
• Refer to your door closer instruction manual to
adjust the door closer so that the door opening
resistance is less than 7 lbs., measured at the
latching edge of the door. The door should close
no faster than 5 seconds. Adjust the doors closing
speed accordingly.
• Make sure the door hinges are not damaged,
are in proper working condition, and lubricated
regularly.
• The door does not operate with a latch mechanism
and opens simply by pushing or pulling, unless
you use an electric strike (#1800384).
• Check width of top door stop. For normal
mounting, ensure that the width is at least 3 1 / 2
”
wide. If the width is less than 3 1 / 2
” wide, a spacer
must be used to securely mount. If width is the
less than 1 5 / 8
”, remove top door stop or do not
install unit (adequate mounting requirements not
available for secure installation).