ADTRAN T1 CSU ACE - Manual (Page 28)

Chapter 2. Installation
28 T1 CSU ACE User Manual 61203022L1-1B
WALLMOUNTING THE UNIT
The T1 CSU ACE may be installed in a wallmount or tabletop
configuration. The following section provides step-by-step instructions
for wallmounting the unit.
Instructions for Wallmounting
Step Action
1. Decide on a location for the T1 CSU ACE. Mount the unit
at or below eye-level so that the LEDs are viewable.
2. Prepare the mounting surface by attaching a board
(typically plywood, 3/ 4" to 1" thick) to a wall stud, using 3”
wood screws.
Important! Mounting to a stud ensures stability. Using
sheetrock anchors may not provide sufficient long-term
stability.
3. Install two #8 (1 1/ 2" or greater in length) wood screws
into the mounted board following these guidelines and
referring to Figure 7:
• Screws should be spaced horizontally, approximately
5” apart. Find exact positioning by using the location
of the two eyed insets on the bottom of the unit as a
guide.
• Screws should be horizontally level with each other.
• Leave approximately 1/4” of the screws protruding
from the board to allow the heads of the screws to
slide into place in the unit’s keyed insets.
4. Slide the keyed insets on the bottom of the T1 CSU ACE
chassis securely onto the screws.
5. Proceed to the steps given in Powering the Unit on page
30.