EOTech Holographic Hybrid Sight II EXPS2-2 with G33.STS Magnifier - Manual (Page 32)

2.5 Installation of Equipment
MOUNTING
The EXPS is equipped with mounting hardware (see Figure 6) to attach to
a 1” (25.4mm) Weaver or MIL-STD-1913 Picatinny style rail. To achieve the
best results and accuracy, the HWS® must be mounted properly. The rail
needs to be as parallel as possible to the bore to permit the maximum
elevation and windage adjustments. If it is required, it is strongly recom-
mend that the rail be installed by a qualified gunsmith. To mount the
sight, please follow these steps.
1. First, push the locking button inward, then turn the quick detach lever so it is away from its closed
and nested position in the base of the sight. The locking button must be pushed down before pulling
on the lever. This will expand the clamping interface to allow the sight to mount onto the rail.
2. The sight contains a small cross bolt that rests in the groove of the Picatinny rail. Move the sight
to the position desired on the rail and allow the post to rest fully in the closest groove.
3. Push the sight as far forward as possible and close the quick detach lever so it is fully shut and
nested in the base of the sight.
4. If at first the sight does not appear to be secure or the lever does not fully close, turn the adjust-
ment nut opposite the quick detach lever clockwise for a tighter fit, and counterclockwise to accom-
modate wider rail tolerances.
24
Figure 6