EOTech Holographic Hybrid Sight II EXPS2-2 with G33.STS Magnifier - Manual (Page 24)

adjustment mechanisms are grooved with a slotted screw head and require the use of a screwdriver,
coin, or spent brass to turn. The elevation and windage adjustments are shown in Fig. 5. For both
elevation and windage, each click will change the bullet’s point of impact 1/2 Minute of Angle (MOA),
¼ inch (6.35mm) at 50 yards (45.7m), or ½ inch (12.7mm) at 100 yards (91m). Also, one full rotation of
either knob will change the point of impact 10 MOA, 5 inches (127mm) at 50 yards (45.7m), or 10
inches (254mm) at 100 yards (91m). To move the point of impact UP, turn the elevation adjustment
LEFT. To move the point of impact RIGHT, turn the windage adjustment RIGHT.
The HWS® elevation and windage adjustments are factory collimated with the bore of the rifle parallel
to the mounting rail. The sight should be close to mechanical zero when mounted on a properly
installed rail. Do not turn the adjustments before mounting the sight on the firearm. Be sure to check
that the mount and sight are securely mounted after initial firing
CAUTION – When encountering an increase in resistance in adjustments, the end of the adjustment
range has been reached. DO NOT turn the adjustments any farther, serious damage may occur to the
sight.
16