EOTech X320 User Manual - Manual (Page 28)

28
AC/DC Power Adapter
Connect the AC/DC Power Adapter to the X320 Connector labeled
“Power”, and to AC power (wall outlet). If batteries are installed
and the AC/DC adapter is connected, the X320 receives its power
from the AC/DC power adapter. It continues to monitor battery
voltage and will stop operating if the batteries are low
The AC/DC Power Adapter provides power to the camera
however, it does not recharge batteries installed in the camera.
Video Cable
Connect the Video Cable to the X320 Connector labeled “Video”,
and to a Video Monitor or video recorder. When Connecting the
Video Cable, the video continues to be displayed on the internal
LCD, so that the user can monitor what is being recorded or
displayed externally. If the internal display is not being used, the
brightness should be set to minimum to extend battery life.
Connector labeled
If batteries are installed
its power
It continues to monitor battery
power to the camera –
recharge batteries installed in the camera.
Connector labeled “Video”,
. When Connecting the
to be displayed on the internal
LCD, so that the user can monitor what is being recorded or
If the internal display is not being used, the