Clinton Electronics CE-M10S - Manual (Page 8)

8
Feature Controls Menu
1. The LANGUAGE can be changed to one of the following: English, French, German, Spanish,
Italian, Dutch, Greek, Swedish.
2. In the OSD CONTROL menu you can set the horizontal and vertical position of the OSD
menu, as well as rotate or mirror the menu, and control the duration the menu is on screen
2-16 seconds.
3. In the IMAGE MODE setting, you can select from one of the following:
*NOTE: if an SD-Card is not present the display will show a settings menu. (Motion & SD-Video settings only)
• Motion: Switches the on-screen image from SD-Card content to camera image upon motion.
• SD-Video: Displays the SD-Card content only (the camera will still supply footage to an external
DVR or display if attached.)
• Camera: Displays camera image only, regardless of SD-Card presence.
4.
Change SD-Card Image/Video/Audio
• Insert the SD-Card into your computer or SD-Card reader.
• Move the desired JPEG image, or AVI video file into the SD-Card
folder.
(For the M10S- the required full screen image size is 1024x786)
(For the M8S the required full screen image size is 800x600)
• Leaving multiple media files on the SD-Card will result in the
device cycling through all loaded media.
• Insert the SD-Card back into the PVM with the contacts facing
out, as shown on the right- DO NOT FORCE IT IN.
• WHEN SD-CARD IS INSERTED, YOU MUST POWER CYCLE
THE UNIT. You can do this by pushing the power button
on the remote control, or by unplugging the power cord
from the wall.
• An SD-Card MUST be inserted, or you will see a “Settings”
Menu.
WHEN SD CARD IS INSERTED,
YOU MUST POWER CYCLE.
You can do this by pushing the POWER
button on the long remote,
or by unplugging the power cord from the wall.
SD Card
16
GB
SD Card
2
GB In the MESSAGE CONTROL setting, you can
turn the message on the bottom of the screen
on or off, as well as select the message to read
“WELCOME” or “RECORDING IN PROGRESS”.
You can also control the message to flash on
and off, or be steady on. Here you can also
disable or enable the flashing LED on the front
of the device.
When an SD-Card is inserted, you
must power cycle the unit by pushing
the power button on the remote, or
unplugging the power from the wall.