beautypg.com

Machine cuts unevenly – Ashland I-110TS User Manual

Page 31

background image

1

Machine cuts unevenly.

1. Cutting edges worn unevenly.

a) Replace cutting edges.

2. Improperly inflated tires.

a) Check air pressure in tires.

Apron closes slowly

or

Apron and push-off are not working well together.

1.

Sequence valve needs adjusting.

a) Remove acorn nut from end of sequence valve with a ½” wrench. Turn adjust-

ment screw, using a 4mm hex wrench, clockwise until front apron rises before

the push-off advances while the earthmover is empty. Turn the adjustment

screw an additional ¼ turn clockwise, then replace the acorn nut and tighten.

b) Torque check valve assembly and int. pilot plug to 25 ft-lbs maximum.

CAUTION! Overtightening check valve assembly and int. pilot plug will cause

internal damage to the sequence valve.

Note: Check valve assembly may leak slightly when torqued to 25 ft-lbs.