Ashland I-200TS4 ver 0612 - Manual (Page 30)

Ashland Scrapers
Ph: (715) 682-4622 Fx: (715) 682-9717
www.AshlandInd.com 28
dozer. Do not ram or jar the earthmover while pushing. Push at a constant speed.
Troubleshooting
Introduction
With proper care and maintenance, your Ashland scraper will give many years of reliable
service. When a situation arises where the earthmover’s performance is not satisfactory,
this section will give some ideas on finding and correcting the problem Consult your
owner’s manual or call (877) 634-4622 for additional troubleshooting help.
Grease Zerk will not Take Grease
1. Grease zerk is plugged: Remove and replace the grease zerk.
2. Pin is frozen: Remove, clean and inspect pin. Replace if necessary.
3. Bushing grease passage is not aligned with grease zerk: Remove, clean, inspect and
realign bushing. Replace bushing if necessary and realign.
Pushoff Rollers Do Not Roll
1. The rollers need lubrication: Check zerk hole and grease. Remove pin, clean, inspect,
and replace if necessary.
2. The roller bushing is worn out: Remove roller assembly and replace bushing. See parts
manual.
Cylinders will not Hold in Preset Position - a.k.a., Cylinder Creep
1. Seals leaking internally: Remove and replace seal kit.
Machine Cuts Unevenly
1. Cutting edges worn unevenly: Replace cutting edges.
2. Improperly inflated tires: Check air pressure in tires.