American Fibertek Net I/O N-111 User Manual
Page 46
46
Reboot Net I/O
The Reboot Net I/O screen allows the user to perform a hardware reset of the N-111.
This will not affect the state of the stored configuration files, but will cause all N-111
systems to reset as if a power interruption had occurred. A single button, “Click here to
reboot”, is provided to restart the system.
The N-111 takes approximately 10 seconds to reboot and return to full function after this
function is used.
When the N-111 is being reset, the aux contact output turn OFF until the reset cycle is
completed, at which time it will behave as configured on the ‘Aux Setup’ page. Any
messages to change aux outputs from other devices on the network will be ignored while
the device is rebooting. Alarm conditions on the alarm input terminal will also be ignored
while the device is rebooting.
When the N-111 is rebooting, all serial data links over the network will be dropped. The
unit will attempt to reestablish them once it has finished rebooting, but any data arriving
on the serial ports during the reboot cycle will be lost.