Asus M4A785G HTPC/RC - Manual (Page 60)

2-10 ASUS M4A785G HTPC Series
2.4.4 CPU/NB Frequency [Auto]
Allows you to select the CPU/NB frequency. The configuration options vary with the CPU Bus
Frequency item settings.
2.4.5 HT Link Frequency [Auto]
Allows you to set the HyperTransport link frequency. The configuration options vary with the
CPU Bus Frequency item settings.
2.4.6 Memory Configuration
Allows you to change the advanced memory settings.
Bank Interleaving [Auto]
Allows you to enable or disable the bank memory interleaving.
Configuration options: [Disabled] [Auto]
Channel Interleaving [XOR of Address bit]
Allows you to set the channel interleaving mode.
Configuration options: [Disabled] [Address bits 6] [Address bits 12]
[XOR of Address bits [20:16, 6]] [XOR of Address bits [20:16, 9]]
Enable Clock to All DIMMs [Disabled]
Allows you to enable unused clocks to DIMMs even the memory slots are no populated.
Configuration options: [Disabled] [Enabled]
MemClk Tristate C3/ATLVID [Disabled]
Allows you to enable or disable MemClk Tri-Stating during C3 and Alt VID.
Configuration options: [Disabled] [Enabled]
Memory Hole Remapping [Enabled]
Allows you to enable or disable memory remapping around memory hole.
Configuration options: [Disabled] [Enabled]
DCT Unganged Mode [Always]
Allows selection of the unganged DRAM mode.
Configuration options: [Auto] [Always]
Power Down Enable [Disabled]
Allows you to enable or disable the DDR power down mode.
Configuration options: [Disabled] [Enabled]
Power Down Mode [Channel]
Appears only when you enable the Power Down Enable item.
Configuration options: [Channel] [Chip Select]
2.4.7 DRAM Timing Configuration
Allows you to change the advanced DRAM timing settings.
The configuration options for some of the following items vary depending on the DIMMs
you install on the motherboard.