beautypg.com

7 system memory, 1 overview, 2 memory configurations – Asus M4A785G HTPC/RC User Manual

Page 22: System memory -10 1.7.1, Overview -10, Memory configurations -10

background image

1.7

System memory

1.7.1

Overview

The motherboard comes with four Double Data Rate 2 (DDR2) Dual Inline Memory Modules

(DIMM) sockets. A DDR2 module has the same physical dimensions as a DDR DIMM but

has a 240-pin footprint compared to the 184-pin DDR DIMM. DDR2 DIMMs are notched

differently to prevent installation on a DDR DIMM socket. The figure illustrates the location of

the DDR2 DIMM sockets:

Channel

Sockets

Channel A

DIMM_A1 and DIMM_A2

Channel B

DIMM_B1 and DIMM_B2

1.7.2

Memory configurations

You may install 512MB, 1GB, 2GB and 4GB unbuffered ECC/non-ECC DDR2 DIMMs into the

DIMM sockets.

• You may install varying memory sizes in Channel A and Channel B. The system maps

the total size of the lower-sized channel for the dual-channel configuration. Any excess

memory from the higher-sized channel is then mapped for single-channel operation.

• Always install DIMMs with the same CAS latency. For optimum compatibility, we

recommend that you obtain memory modules from the same vendor.

• Due to the memory address limitation on 32-bit Windows OS, when you install 4GB

or more memory on the motherboard, the actual usable memory for the OS can be

about 3GB or less. For effective use of memory, we recommend that you install a 64-bit

Windows OS when having 4GB or more memory installed on the motherboard.

• This motherboard does not support DIMMs made up of 256 Mb chips or less. (Memory

chip capacity counts in Megabit, 8 Megabit/Mb=1 Megabyte/MB.)

• Due to AM3/AM2+ CPU limitation, only one DDR2 1200(O.C.)/1066 DIMM is supported

per channel. When four DDR2 1200(O.C.)/1066 DIMMs are installed, all DIMMs run at

800Mhz frequency by default for system stability.

• The default memory operation frequency is dependent on its SPD. Under the default

state, some memory modules for overclocking may operate at a lower frequency than

the vendor-marked value.

• For system stability, use a more efficient memory cooling system to support a full

memory load (4 DIMMs) or overclocking condition.

1-10

ASUS M4A785G HTPC Series

This manual is related to the following products: