GE 45144 GE Choice Alert Key-chain Remote - Manual (Page 5)

4 5
Activating the Battery
The Keychain Remote is packaged with the battery
installed, but not activated. To activate the battery, remove
the battery door by pushing down and sliding the door
outward. Remove the yellow battery isolation strip. When
removed, the Keychain Remote will be active. Replace
battery cover.
Assigning a Keychain Remote to a Device Location
The Control Center is designed to store up to four Remote
Transmitters, such as the Keychain Remote. In order to
ensure that the Keychain Remote will operate only with
your Control Center, it must be assigned to one of the four
device locations in the Control Center.
1. Press and hold the Learn button on the Control
Center. You will hear a short beep, followed by a long
continuous beep. Release the Learn button. The
Control Center is now in Learn mode.
2. On the Control Center press and release the button
(1,2,3 or 4) for the device number you want to assign
the Keychain Remote. The LED indicator for that device
number will begin to flash.
1 2 3 4
Arm
Zone
Armed Power 1 2 3 4
Alert
Chime
Off
Mute
Learn
Input DC 12V
- +
Step 1
Press and hold
the Learn button
for three seconds
Step 3
To activate the Keychain
Remote press the disarm button.
Step 2
Press and release the
Device number