GE ZV54ISHSS - Manual (Page 17)

49-80209-5
17
Installation Instructions
67(3
CONNECT ELECTRICAL
Verify that power is turned off at the source.
WARNING:
If house wiring is not 2-wire
with a ground wire, a ground must be provided by
the installer. When house wiring is aluminum, be
sure to use UL approved anti-oxidant compound
and aluminum-to-copper connectors.
ATTENTION –
Si le câblage de la
maison n’est pas du type à deux fils avec un fil de
terre, l’installateur doit fournir un circuit de terre.
Quand les fils de la maison sont en aluminium,
il prendre soin d’utiliser de la pâte antioxida-
tion approuvée par UL et des connecteurs pour
l’aluminium-cuivre.
STEP 9 INSTALL THE MOTOR
• From the inside of the hood, slip motor into the
attachment slot on the left.
• Rotate motor upwards until it snaps into the spring
clip on the right.
• Secure the motor to the hood with the machine
screw and lock washer (Screw is marked with red
paint.)
• Plug blower cable into the connector on the blower.
Spring
Clip
Outlet
Attachment
Slot
Junction Box
• Plug cable at the top of the hood into the junction
box connector. Route cable so it won’t be pinched
or damaged when the duct cover is lowered.
Top
• Install strain relief onto the knockout of the
junction box.
• Insert house wiring through strain relief and tighten.
• Use wire nuts to connect incoming ground to green,
white to white and black to black.
• Push wires into junction box and replace cover. Be
sure wires are not pinched.
Screw F
Spring
Clip
Attachment Screw
and Washer
Attachment
Slot
IMPORTANT: Connector
ends are designed to
mate only one way.
Match flat and round
connectors as shown.