GE ZDP364NDPSS - Manual (Page 16)

Installation
CHECK BURNERS
Check to be sure that burner heads and caps
are securely seated.
• Check for proper ignition:
– Push in one control knob and turn to LITE
position.
– The igniter will spark and the burner will light; the
igniter will cease sparking when the burner is lit.
– First test may require some time, while air is
flushed out of the gas line.
– Turn knob to OFF.
– Repeat the procedure for each burner.
IMPORTANT: If the igniter electrodes continue to
spark after the burners are lit, check that each
burner component is assembled properly. Refer to
the Owner’s Manual.
• Burner flames should be blue and stable with no
yellow tips, excessive noise or lifting of the flame
from the burner. If any of these conditions exist,
check that the burner ports are not blocked. If one
of these conditions continues, call for service.
STEP 9
16
FINALIZE INSTALLATION
Place the burner grates over the burners. The
grates should be seated and should not rock.
The griddle is secured with screws. It is designed to
be stationary and should not be removed.
The griddle has two leveling screws beneath the
rear flue cover that can be used to adjust to the
desired slope.
The two inner screws are clamping screws for
securing the griddle in place. Loosen these two screws
before leveling. Do not remove these two screws.
The two outer screws are leveling screws. Do not
remove these two screws. They can be turned to
level the griddle or to provide a forward slope to
help grease and oils drain away from the food
being cooked.
After leveling the griddle, hand-tighten the
clamping screws; do not over-tighten.
INSTALLATION CHECKLIST
■ Make sure all controls are left in the OFF position.
■ Make sure the flow of combustion and ventilation
air to the range is unobstructed.
■ Recheck Steps:
Double check to make sure everything in this
manual has been completed. Rechecking steps
will ensure safe use of the range.
NOTE: The rating plate is located on the bottom
of the control panel and is visible when the oven door
is opened. The model and serial number is behind
the left knob and is visible when the knob is pulled off.
Burner Cap Not Properly Seated
Burner Cap Properly Seated
Griddle Flue Cover
Clamping
Screws
Leveling Screws