GE ZDP364NDPSS - Manual (Page 15)

15
REPLACE OVEN DOOR(S)
Skip this step if oven doors are in place.
IMPORTANT: Do not lift the door by the handle.
To replace the oven doors:
• Firmly grasp the door at the top sides.
This is critical.
• Approach the range with the door angled in a
vertical position.
• Guide the hinges into the slots.
• Push the door in firmly while opening.
• Once in position, open the door completely. Push
the hinge locks back in and toward the front
frame.
CAUTION:
Take care when replacing
the oven doors. If the hinge latch is not securely
locked, the hinge may snap back and separate.
If the hinge separates, you must apply pressure
(possibly with your foot) to press it back together
and then engage the hinge latch.
STEP 8
Installation
LEVEL THE RANGE
WARNING
The range must be level and be supported by the
OHJV³QRWWKHZKHHOV7KHUDQJHFRXOGPRYHLIWKH
wheels make contact with the floor. Be sure all legs
make contact with the floor in any installation.
• All legs must be leveled after the product is
installed.
• Check to be sure the adjoining cabinets/
countertops are level, front to back and left to right
across the opening of the range.
• Measure the distance from the floor to the top of
the countertop in the left and right rear corners.
• Adjust the height of the range to countertop height
or higher.
IMPORTANT: This range should always be installed
at countertop height or higher. DO NOT INSTALL
THE RANGE LOWER THAN ADJACENT COUNTERTOP
HEIGHT. The range must be supported by all 4 legs,
regardless of countertop height.
FRONT LEG ADJUSTMENT
• Slide front cylinders up to adjust front leveling legs.
Be careful not to damage cylinder.
• A leveling leg wrench is supplied. Reach under the
front of the range near the right side. Locate and
remove a thumb screw, then slide wrench out of
the slot.
STEP 7
REAR LEG ADJUSTMENT
• Remove two screws from rear vent trim. Slide vent
trim forward, then lift up to remove.
• Find the two rear leg extension rods. Use a 1/4” driver
or wrench to adjust the left or right rear legs.
• Use the supplied wrench to turn the front leveling
legs. Turn clockwise to raise the range above the
wheels. Turn counterclockwise to lower the legs.
• Be sure to return the wrench to its storage slot for
future use.
Slide leg
cylinder up.
Thumb Screw
LEVEL THE RANGE (cont.) STEP 7
Rear Leg
Extension Rod
Rear Vent Trim
• Replace the rear vent trim using the original screws.