GE GTDL210EDWW - Manual (Page 7)

ADDING ELBOW AND DUCT FOR
EXHAUST TO RIGHT SIDE OF CABINET
• Preassemble 4” elbow with 4” duct. Wrap duct tape
around joint.
‡,QVHUW GXFW DVVHPEO\ HOERZ ¿UVW WKURXJK WKH VLGH
opening and connect the elbow to the dryer internal
duct.
CAUTION:
Be sure not to pull or damage the
electrical wires inside the dryer when inserting the duct.
• Apply duct tape as shown on the joint between the
dryer internal duct and the elbow.
ADDING ELBOW FOR EXHAUST
THROUGH BOTTOM OF CABINET
• Insert the elbow through the rear opening and connect
it to the dryer internal duct.
• Apply duct tape on the joint between the dryer internal
duct and elbow, as shown above.
DUCT
TAPE
CAUTION:
Internal duct joints must be
secured with tape, otherwise
they may separate and cause
a safety hazard.
ADDING COVER PLATE TO REAR OF
CABINET (SIDES AND BOTTOM EXHAUST)
Connect standard metal elbows and ducts to complete
WKH H[KDXVW V\VWHP &RYHU EDFN RSHQLQJ ZLWK D SODWH .LW
:(0 DYDLODEOH IURP \RXU ORFDO VHUYLFH SURYLGHU 3ODFH
GU\HULQ¿QDOORFDWLRQ
CAUTION:
Internal duct joints must be secured with tape,
otherwise they may separate and cause a
safety hazard.
PL ATE
(KIT WE1M454)
WARNING-
NEVER LEAVE
THE BACK OPENING WITHOUT THE
PLATE (KIT WE1M454).
DUCT
TAPE
Installation Instructions
7
CHANGING DIRECTION OF DOOR OPENING
2SHQWKHGRRUDQGUHPRYHWKH¿OOHUSOXJVRSSRVLWHWKH
hinges. With the door completely open, remove the
bottom screw from each hinge on the dryer face. Insert
these screws about half way into the TOP holes, for each
KLQJHRQWKHRSSRVLWHVLGHZKHUH\RXUHPRYHGWKH¿OOHU
SOXJV$SSO\¿UPSUHVVXUHWRJHWWKHVFUHZVVWDUWHG
2. Loosen the top screw from each hinge on the dryer face
half way. With one hand holding the top of the door and
the other hand holding the bottom, remove the door
from the dryer by lifting it UP and OFF.
LOOSEN EACH TOP HINGE
6&5(:+$/):$<$1'/,)77+(
'22583$1'2))
11
5(029( BOTTOM6&5(:)520($&++,1*(
AND INSTALL HALF WAY INTO EACH TOP OF
OPPOSITE HINGE HOLES
5(029(3/8*6$1'.((3
)25,16(57,21,172
THE OPPOSITE SIDE