GE GTDL210EDWW - Manual (Page 6)

Detach and remove the bottom or right side knockout as
desired. Remove the screw inside the dryer exhaust duct
and save. Pull the duct out of the dryer.
REMOVE
SCREW
AND SAVE.
REMOVE DESIRED
KNOCKOUT (ONE ONLY).
Cut the duct as shown and keep portion A.
9"
A B
FIXING HOLE
Through the rear opening, locate the tab in the middle of
the appliance base. Lift the tab to about 45º using a flat
blade screwdriver.
BEND TAB
UP 45
o
Reconnect the cut portion (A) of the duct to the blower
housing. Make sure that the shortened duct is aligned with
the tab in the base. Use the screw saved previously to secure
the duct in place through the tab on the appliance base.
PORTION "A"
FIXING
HOLE
7 BATHROOM OR BEDROOM INSTALLATION
• The dryer MUST be vented to the outdoors. See EXHAUST
,1)250$7,21VHFWLRQ
• The installation must conform with local codes or, in the
DEVHQFHRIORFDOFRGHVZLWKWKH1$7,21$/(/(&75,&$/
&2'($16,1)3$12
MOBILE OR MANUFACTURED HOME
INSTALLATION
‡,QVWDOODWLRQ PXVW FRQIRUP WR WKH 0$18)$&785('
+20(&216758&7,21 6$)(7<67$1'$5'7,7/(
3$57 RU ZKHQ VXFK VWDQGDUG LV QRW DSSOLFDEOH
ZLWK $0(5,&$1 1$7,21$/ 67$1'$5' )25 02%,/(
+20($16,1)3$12%
• The dryer MUST be vented to the outdoors with the
termination securely fastened to the mobile home
VWUXFWXUH6HH(;+$867,1)250$7,21VHFWLRQ
• The vent MUST NOT be terminated beneath a mobile or
manufactured home.
‡7KHYHQWGXFWPDWHULDO0867%(0(7$/
• Do not use sheet metal screws or other fastening devices
which extend into the interior of the exhaust vent.
• See section 2 for electrical connection information.
8
TAB LOCATION
ADDING NEW DUCT
GARAGE INSTALLATION (IF ALLOWED
BY LOCAL CODES)
‡'U\HUVLQVWDOOHGLQJDUDJHVPXVWEHHOHYDWHGLQFKHV
FPDERYHWKHÀRRU
9
Installation Instructions
6
10 DRYER EXHAUST TO RIGHT OR
BOTTOM CABINET
WARNING -
BEFORE PERFORMING
THIS EXHAUST INSTALLATION, BE SURE
TO DISCONNECT THE DRYER FROM ITS
ELECTRICAL SUPPLY. PROTECT YOUR
HANDS AND ARMS FROM SHARP EDGES
WHEN WORKING INSIDE THE CABINET.
BE SURE TO WEAR GLOVES.