GE JV566HSS - Manual (Page 14)

TROUBLESHOOTING CHECKLIST
If the hood seems to be operating at high speed when
the control is not set on high, or if ventilation seems
LQDGHTXDWHFKHFNWKHIROORZLQJ
‰ Knockouts not removed from hood.
‰ Damper blade not opening.
‰ Reduced airflow because the duct is too small or the
duct length is too long.
‰ The duct is blocked.
‰ Undersized or restrictive wall or roof cap.
REPLACE WIRING COVER
Replace the wiring cover.
14
FOLLOW ELECTRICAL CODE
Complete the electrical wiring according to National
Electrical Code and local codes.
NOTE: This hood must be permanently grounded.
Connect house wiring (120 VAC) to hood wiring.
CONNECT WIRING
Connect house black to hood black wire, house white
to hood white wire, and house ground to hood green/
yellow wire. Securely tighten the strain relief clamp
onto the house wiring.
19
20
21
22
INSTALL LIGHT BULBS
3XUFKDVHDQGLQVWDOOWZR3$5:PD[LPXP
halogen bulbs. Light bulbs are not included with
the hood.
WARNING:
To reduce the risk
of electric shock, do not connect electrical power
to the hood without both bulbs in place.
18
CONNECT DUCTWORK
TO HOOD
Use duct tape to make joints secure and air tight.
Duct tape
REPLACE FILTERS
The installation is complete. Turn on power at service
panel, and test for proper operation.
Installation Instructions