GE JRP28SKSS - Manual (Page 17)

GEAppliances.com
Non-Self-Clean Oven Interior
RQVWDQGDUGFOHDQPRGHOVRURQORZHURYHQ
With proper care, the porcelain enamel finish
RQWKHLQVLGHRIWKHRYHQ³WRSERWWRPVLGHV
EDFNDQGLQVLGHRIWKHGRRU³ZLOOVWD\QHZ
looking for years.
Let the oven cool before cleaning. We
recommend that you wear rubber gloves when
cleaning the oven.
Soap and water will normally do the job. Heavy
spattering or spillovers may require cleaning
with a mild abrasive cleaner. Soap-filled scouring
pads may also be used.
Do not allow food spills with a high sugar or
DFLGFRQWHQWVXFKDVWRPDWRHVVDXHUNUDXWIUXLW
MXLFHVRUSLHILOOLQJWRUHPDLQRQWKHVXUIDFH
They may cause a dull spot even after cleaning.
Household ammonia may make the cleaning
job easier. Place 1/2 cup in a shallow glass or
pottery container in a cold oven overnight. The
ammonia fumes will help loosen the burned-on
grease and food.
If necessary, you may use an oven cleaner.
Follow the package directions.
„ Do not spray oven cleaner on the electrical
controls and switches because it could cause
a short circuit and result in sparking or fire.
„ Do not allow a film from the cleaner to build
XSRQWKHWHPSHUDWXUHVHQVRU³LWFRXOGFDXVH
WKHRYHQWRKHDWLPSURSHUO\7KHVHQVRULV
ORFDWHGDWWKHWRSRIWKHRYHQ&DUHIXOO\ZLSH
the sensor clean after each oven cleaning,
being careful not to move the sensor as a
change in its position could affect how the
oven bakes.
„ Do not spray any oven cleaner on the oven
door, handles or any exterior surface of
the oven, cabinets or painted surfaces. The
cleaner can damage these surfaces.
Wire cover holder
Oven Light Bulb
RQVRPHPRGHOV
CAUTION:
Before replacing your
oven light bulb, disconnect the electrical power
to the oven at the main fuse or circuit breaker
panel.
Be sure to let the light cover and bulb cool
completely.
To remove the cover:
Hold a hand under the cover so it doesn’t
fall when released. With fingers of the
same hand, firmly push back the wire
cover holder. Lift off the cover.
Do not remove any screws to remove the cover.
Replace bulb with a 40-watt appliance
bulb.
To replace the cover:
Place it into grooves of the light
receptacle. Pull wire forward to the center
of the cover until it snaps into place.
Connect electrical power to the oven.
Oven Light Bulb
RQVRPHPRGHOV
NOTE: 7KHJODVVFRYHURQVRPHPRGHOVVKRXOG
be removed only when cold. Wearing latex gloves
may offer a better grip.
Before replacing the bulb, disconnect electrical
power to the oven at the main fuse or circuit
breaker panel. Let the bulb cool completely
before removing it. For your safety, do not
touch a hot bulb with a damp cloth. If you do,
the bulb will break.
To remove:
Turn the glass cover counterclockwise 1/4
turn until the tabs of the glass cover clear the
grooves of the socket. Remove the bulb.
To replace:
Put in a new 40-watt appliance bulb. Place the
tabs of the glass cover into the grooves of the
socket. Turn the glass cover clockwise 1/4 turn.
NOTE:
„ A 40-watt appliance bulb is smaller than a
standard 40-watt household bulb.
„ Install and tighten the cover clockwise.
„ Reconnect electrical power to the oven.
„ For improved lighting inside the oven, clean
the glass cover frequently using a wet
cloth. This should be done when the oven is
completely cool.
Bulb
Socket
Tab
Max
length
3 1 ø
2
”
Glass cover
17