Airlink PinPoint EDGE/GPRS User Manual

Page 91

PinPoint EDGE/GPRS - User Guide, version 2.32

AT Commands: UDP

This group includes commands specific to UDP communications.

FIGURE 1.

Common : UDP

AIP=n

HOR=n

MDhh

UDP

Allow IP address.

n=0 Allow only the IP address specified in S53 to connect when UDP auto answer is enabled (S82=2).

n=1 Allow any incoming IP address to connect when UDP auto answer is enabled (S82=2).

Note:

Always subject to any Friends filters that may be defined.

Half-Open Response - In UDP auto answer (half-open) mode:

n=0 No response codes when UDP session is initiated.

n=1 RING CONNECT response codes sent out serial link before the data from the first UDP packet.

Note: Quiet Mode must be Off.

Default power-up mode for the serial port.

When the PinPoint is power-cycled, the serial port enters the mode specified by this command
after 5 seconds. On startup, typing ATMD0 within 5 seconds changes the mode to normal (AT
command) mode.

hh (hex byte)=00 : normal mode