HP 350 G1 Notebook PC - Manual (Page 64)

Save your work and shut down the computer before adding or replacing a memory module or hard
drive.
If you are not sure whether the computer is off, turn the computer on by pressing the power button.
Then shut down the computer through the operating system.
Removing or replacing the service door
Removing the service door
Remove the service door to access the hard drive and other components.
1. Remove the battery (see Inserting or removing the battery on page 44 ).
2. With the battery bay toward you, remove the screw (1), tilt the service door up (2), and then lift
the service door away (3).
Replacing the service door
Replace the service door after accessing the memory module slot, hard drive, regulatory label, and
other components.
1. Tilt down the service door to align the front edge of the service door near the front edge of the
computer (1).
2. Insert the alignment tabs (2) on the rear edge of the service door with the notches on the
computer, and tilt down and into place.
54 Chapter 8 Drives ENWW