HP Pavilion fx50 15 inch Flat Panel Monitor - Manual (Page 22)

hp pavilion fx50 15” lcd monitor
Tr oublesh ootin g
20 English English
En
glish
Troubleshooting Troubleshooting Troubleshooting Troubleshooting
Before calling HP check the following:
There is no picture and LED is off:
•
Check that the monitor is switched on.
• Check that the power cord is properly connected.
• Check the electrical outlet.
• Test and see if monitor works on another PC previously set to
another monitor’s supported resolution.
There is no picture and the LED is on:
•
Check that the monitor is not in power saving mode.
• Adjust the Contrast and Brightness through OSD or control
buttons.
• Check that the PC is switched on.
• Check that the video cable has no bent pins.
• Test that the monitor works on another PC previously set to another
monitor’s supported resolution.
The picture is fuzzy:
•
Adjust your monitor, using the Automatic Adjustment function
(refer to “Auto Adjustment” on page 14).
• If you are running a Windows 95/98/2000 Operating System
then install the INF file - Plug and Play driver (refer to “How To
Install The Drivers” on page 8).
• Change the resolution to the recommended resolution 1024 x 768
at 60Hz.
Pixels are missing:
•
Refer to “LCD Monitor Quality and Pixel Policy” on page 21.
Colors are not pure:
•
Check that the video cable has no bent pins and is firmly attached
to both the PC and monitor Video Connectors.
• Recall the colors default factory settings (refer to “Miscellaneous”
on page 17).
• Adjust the RGB (Red, Green and Blue) colors to as required (refer
to “Color Adjustment” on page 14).
X