HP MSA 2040 SAN Storage - Manual (Page 19)

: 19
NOTE: You can expect to see certain errors in the log file when commands are executed to ensure that
volumes are in a particular state if the volumes are already in that state. These errors are -3395
(Replication is not active on this secondary volume) and -10306 (Unable to set
the specified volume as the primary volume because the specified volume is
already a primary volume
). You can safely disregard these error messages if they occur under these
circumstances.
1104 Response from array at {ipAddr} did not include
status indication.
Check the health of the array and restart the
management controller if necessary.
1105 Failed to run command "{cmd}" on array at
{system}: {err}
Verify the IP address configuration on the array and
on the host, and check network connectivity.
2001 Volume {volume}({name}) is already unmapped. SRM requested that a volume be prepared for
failover, but the volume is already prepared.
2002 No data found for {volume} replication image
{imageSn} ({err}).
Verify that replication has started for volume
{volume}.
2003 querySyncStatus: No data found for replication
image {imageSn} for volume {vol} ({err}).
Verify that replication has started for the specified
volume.
Table 1 SRA error messages and suggested actions