HP D2000 Disk Enclosures - Manual (Page 33)

2. Unlatch and swing out the latch handle on the drive. Then, slide the drive into the bay (1),
pressing firmly on the drive to seat it. Close the latch handle (2), pressing firmly until it locks in
place.
IMPORTANT:
When a drive is inserted in an operational enclosure, the drive LEDs flash to indicate that the
drive is seated properly and receiving power.
3. Determine the status of the hard drive (see Drive status reporting ).
IMPORTANT:
For proper airflow and cooling, a drive blank must remain installed in all unused drive bays.
D2600/D2700 Disk Enclosure User Guide 33